School of Environmental Engineering (Articles): Recent submissions
Now showing items 81-100 of 129
-
Catalytic dehydrogenation of methylcyclohexane (MCH) to toluene in a palladium/alumina hollow fibre membrane reactor
(Malaysian Technical Universities Network (MTUN), 2012-11-20)A compact multifunctional Pd/alumina hollow fibre membrane reactor (HFMR) has been developed and used for the catalytic dehydrogenation of methylcyclohexane to toluene. The developed HFMR consists of a thin and defect-free ... -
Characterization of LUSI mud volcano as geopolymer raw material
(Trans Tech Publications, 2012)The mud of mud volcano samples were collected from an eruption site named 'LUSI' (Lumpur "mud" -Sidoarjo), East Java, Indonesia for characterization. Analysis showed that, the major constituents of mud are SiO 2 and Al 2O ... -
Correlation between Na 2SiO 3/NaOH ratio and fly ash/alkaline activator ratio to the strength of geopolymer
(Trans Tech Publications, 2012)Geopolymer requires an alkaline activator to induce it pozzolanic property and to accelerate the geopolymerisation process. The geopolymerisation process occurs due to the mixing of fly ash, sodium silicate and sodium ... -
Microstructure study on optimization of high strength fly ash based geopolymer
(Trans Tech Publications, 2012)The compressive strength and microstructural characteristics of fly ash based geopolymer with alkaline activator solution were investigated. The sodium hydroxide and sodium silicate were mixed together to form an alkaline ... -
The role of sodium surface species on electrochemical promotion of catalysis in a Pt/YSZ system: The case of ethylene oxidation
(Elsevier Inc., 2013-07)The role of sodium addition as foreign (impurity) species on the electrochemical promotion of ethylene oxidation in a Pt/YSZ system was investigated. It was found that the presence of sodium surface species on the catalyst ... -
Effect of alkali concentration on mechanical properties of kaolin geopolymers
(Foundation for Materials Science and Engineering, 2012)Alkali concentration is the most significant factor in geopolymerization process that must be taken into consideration during the synthesis of kaolin geopolymers. The kaolin geopolymers were prepared by mixing kaolin and ... -
Enhanced photocatalytic activity of fish scale loaded TiO 2 composites under solar light irradiation
(Elsevier B.V., 2012-06)Fish scale (FS) loaded TiO2 composites were investigated as photocatalysts in degradation of Methyl Orange under solar light irradiation. Composites were prepared through sol-gel method by varying mass ratio of TiO2/FS at ... -
Photocatalytic degradation of reactive black 5 by fish scale-loaded TiO 2 composites
(Springer Science+Business Media B.V., 2012-09)Titania and TiO 2/fish scale composites at different mass ratios (90:10, 70:30, and 50:50) were prepared by sol-gel method for application as photocatalysts in this study. Fish scale, synthesized TiO 2, and TiO 2/fish scale ... -
Study on solids-to-liquid and alkaline activator ratios on kaolin-based geopolymers
(Elsevier Ltd., 2012-10)Kaolin and alkali activator were mixed with the solids-to-liquid ratios in range of 0.60-1.20 (Al 2O 3/Na 2O molar ratio of 0.63-1.27). Sodium silicate and sodium hydroxide ranged between 0.16 and 0.36 (SiO 2/Na 2O molar ... -
Effect of mechanical activation on kaolin-based geopolymers
(Trans Tech Publications, 2012)Raw materials kaolin was subjected to mechanical modification; the effect of the mechanical activation of kaolin on the compressive strength and morphological properties of the geopolymers has been studied. Mechanical ... -
Curing Behavior on kaolin-based geopolymers
(Trans Tech Publications, Switzerland., 2012)This paper aims at investigating the influence of curing process on kaolin-based geopolymers. Kaolin-based geopolymers were prepared by the alkali-activation of kaolin with alkali activating solution (mixture of NaOH and ... -
Feasibility of producing wood fibre-reinforced geopolymer composites (WFRGC)
(Trans Tech Publications, 2013)Wood fibres have long been known as a fibre reinforcement for concrete. Due to its availability and low production cost, this natural fibre has been used in less developed country where conventional construction materials ... -
Lightweight fly ash-based geopolymer concrete
(Trans Tech Publications, 2013)The experiments of this study were preformed to study the synthesis process for lightweight aggregate geopolymer concrete (LWAGC) using normal sand as a fine aggregate and expanded clay as lightweight aggregate. The LWAGC ... -
Calcined kaolin geopolymeric powder: Influence of water- to geopolymeric powder ratio
(Trans Tech Publications, 2012-07)This paper describes the synthesis of calcined kaolin geopolymeric powder from the alkaline activation of calcined kaolin followed by solidification and pulverizing process. The geopolymeric powder was used by just adding ... -
Influence of solidification process on calcined kaolin geopolymeric powder
(Trans Tech Publications, 2012-02)This paper aims at investigating the influence of solidification condition on the processing of calcined kaolin geopolymeric powder. This is a new process developed using the geopolymerization process. Geopolymer slurry ... -
Processing and characterization of calcined kaolin cement powder
(Elsevier Ltd, 2012-05)Abstract This paper aimed at investigating the possibility of calcined kaolin to produce cement powder that could be an alternative to Portland cement by applying geopolymerization process. Cement paste was firstly made ... -
Optimization of solids-to-liquid and alkali activator ratios of calcined kaolin geopolymeric powder
(Elsevier Ltd, 2012-12)This paper investigates the effect of S/L and alkali activator ratios on the synthesis of geopolymeric powder. Geopolymeric powder was synthesized by applying geopolymerization process. By adopting the concept of "just ... -
Fly ash-based geopolymer lightweight concrete using foaming agent
(MDPI, Basel, Switzerland., 2012-06)In this paper, we report the results of our investigation on the possibility of producing foam concrete by using a geopolymer system. Class C fly ash was mixed with an alkaline activator solution (a mixture of sodium ... -
The influence of curing periods on the compressive strength of fly ash-based geopolymer at different aging times
(Trans Tech Publications, 2012)The results of the current experimental investigation indicate the significant effect of the heating periods on the compressive strength of fly ash-based geopolymers prepared at different alkaline liquid content at both ... -
Optimization of alkaline activator / fly ash ratio on the compressive strength of manufacturing fly ash-based geopolymer
(Trans Tech Publications, 2012)Fly ash and a mixture of alkaline activators namely sodium silicate (Waterglass) and sodium hydroxide (NaOH) solution were used for preparing geopolymer. The aim of this research is to determine the optimum value of the ...