Physicochemical properties of pyrolitic carbon black from waste tyres
Date
2014Author
Umi Fazara, Md. Ali, Dr.
Ishak, Jainoo
Khairul Nizar, Ismail, Assoc. Prof. Dr.
Kamarudin, Hussin, Brig. Jen. Dato' Prof. Dr.
Fahmi, Muhammad Ridwan, Dr.
Metadata
Show full item recordAbstract
Waste tyres which are mainly generated from automotive industries have become a major environmental problem to the local authorities, the tyre industries and tyre dealer. When tyres are no longer usable due to worn-out, defect or service failure they are usually dumped in the landfill sites. Pyrolysis is a process of the thermal decomposition of waste tyres in the absence of air and the oxygen. Pyrolysis may be an environmentally friendly process to transforms used tyres into gas, oil, steel and carbon black waste. The rate of recovery is 45 wt % for fuel, 30 wt % for carbon black and 10 wt % for steel wires for each end-of-life tyres. In this paper, the potential use of pyrolised carbon black generated from pyrolysis process of waste tyres is investigated. From the physical analysis of this carbon black waste, it was observed that there is various refraction particles sizes from the sieve test and different morphologies gathered from SEM analysis. Moreover, X-Ray Fluorescence (XRF) and TGA/DTG analysis on the carbon black waste showed high content of inorganic additives such as Silica (Si), Calcium (Ca) and Iron (Fe) which contaminate the sample. The carbon black waste started to decompose at a lower temperature of 480°C to 680°C compared to standard black at 500°C to 740°C. The test results gathered in this paper will act as a base-line towards alternative material or to replace the commercial carbon black available in the market.
Collections
- Umi Fazara Md. Ali, Assoc. Prof. Ir. Dr. [7]
- Khairul Nizar Ismail, Associate Professor Dr. [54]
- Fahmi Muhammad Ridwan,Assoc. Prof. Dr. [17]
- Center of Excellence for Geopolymer and Green Technology (CEGEOGTECH) (Articles) [135]
- Kamarudin Hussin, Brig. Jen. Datuk Prof. Dr. [253]
- School of Environmental Engineering (Articles) [129]