dc.creator | Mohammed, Ghazwan Raheem | |
dc.date | 2016 | |
dc.date.accessioned | 2023-03-23T02:02:45Z | |
dc.date.available | 2023-03-23T02:02:45Z | |
dc.identifier.uri | http://dspace.unimap.edu.my:80/xmlui/handle/123456789/78179 | |
dc.description | Master of Science in Manufaturing System Engineering | en_US |
dc.description.abstract | The CNC milling machine was used to machine the specimens made from stainless steel AISI 316 based on the selected parameters setting. Specimens with 6 mm in thickness obtaining was used. The material removal rate (MRR) was calculated by
dividing machine time the weight of the specimen weight before and after the cutting process. The second performance surface roughness (SR) and it was measured by MITUTOYO CS-3100 device. Taguchi Method was utilized as in layout the
experimental to optimize MRR, SR. It was found that prediction maximum value MRR was 4.86 mm3/s under setting spindle speed 2500 m/min , feed rate 250 mm/min , and depth of cut 0.1 mm . On the other hand the prediction minimum SR value 2.85 μm, was under setting spindle speed 500 m/min, feed rate 250 mm/min, and depth of cut
0.2 mm. Confirmation tests were run to verify. The prediction it was found the
experimental results of MRR and SR for within 10% percentage of the prediction value. | en_US |
dc.language.iso | en | en_US |
dc.publisher | Universiti Malaysia Perlis (UniMAP) | en_US |
dc.rights | Universiti Malaysia Perlis (UniMAP) | en_US |
dc.subject | Stainless steel | en_US |
dc.subject | Milling | en_US |
dc.subject | CNC Milling Machine | en_US |
dc.title | Optimization of process parameters on surface roughness and material removal rate of stainless steel AISI 316 in CNC milling process | en_US |
dc.type | Dissertation | en_US |
dc.contributor.advisor | Bhuvenesh, Rajamony, Prof. Dr. | |
dc.publisher.department | School of Manufacturing Engineering | en_US |