Now showing items 1-20 of 641

    • Properties of paper waste sludge reinforced with sugarcane bagasse 

      Mohd Azrauhisham, Sudin (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010)
      In this study, the raw materials used are treated paper waste sludge and sugar cane bagasse. This study aims on the properties of both industrial and agricultural wastes and the effects of the wastes blending by combining ...
    • Decolorization of azo dye by ozonation 

      Suhaida, Mohamed Arshad (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010-02)
      Decolourization and Chemical Oxygen Demand (COD) removal of azo dye solution in different ozonation time and biodegradation processes were evaluated to apply for wastewater treatment containing azo dye. Reactive Red 120, ...
    • The Used of Waste Tire as Crumb Rubber Mortar Porous Paving 

      Nur Fatiha, Mohamad Yusup (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010-02)
      In this study, waste tires and clay were used as raw materials incorporating in mortar. Standard cement-sand mortar were prepared and waste tires (crumb rubber) was replaced the sand by absolute volume method with 5, 10, ...
    • The study of industrial water pollution at Kawasan Perindustrian Jejawi, Perlis 

      Juliana, Ab Rahman (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010-03)
      Nowadays, the importance of river quality has become vital and the significance of river quality could not be denied anymore. This study has been conducted to asses the extent of heavy metal and the water quality of the ...
    • Phytoremediation of azo dye containing wastewater by using up-flow constructed wetlands 

      Danny, Leonard Dugil (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010-03)
      Phytoremediation of a xenobiotic, like a textile azo-dye, acid orange 7 (AO7) in a pilot constructed wetland (CW), is feasible even for very high concentrations ([AO7] = 96.61 ± 3.57 mg/l). Removal efficiencies of approximately ...
    • The rehabilitation of open dumping to sanitary landfill at Matang Taiping 

      Zaliha, Zakaria (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineeering, 2010-04)
      Open dumping Matang, Taiping was upgraded to a sanitary landfill more systematically with some of these sites have closed the phase I and II, while phase III is fully restored. This study aimed to know the process of ...
    • Concrete sludge and paper sludge (CSPS) brick 

      Nor Asadah, Mohd Daud (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010-04)
      Paper sludge is a waste from pulp and paper industry while concrete sludge is a waste from construction industry, has caused environmental impact problem besides the increasing of disposal cost. Focus this study, to ...
    • Adsorption of copper solution on chitosan beads adsorbent 

      Noor Husaiha, Hussain (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010-04)
      The use of waste as an adsorbent for removal of copper from aqueous solution was investigated due to its low cost value. Chitosan which was derived from crustacean shells was used in this study. The adsorption experiment ...
    • Modelling of PM10 concentration in industrialized area in Malaysia: A case study in Nilai & Shah Alam 

      Tan, Cheng Yau (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010-04)
      In Malaysia, the predominant air pollutants are suspended particulate matter (SPM) and nitrogen dioxide (NO2). This research is on PM10 as they may trigger harm to human health as well as environment. Six distributions, ...
    • Potential use of red gypsum as glaze product 

      Syarifah Syazwani, Syed Zulkiple (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010-04)
      During the extraction process of titanium (iv) oxide from its ores, red gypsum were produced as the by-product. A total of 340,000 tonnes of red gypsum were produced per year in Malaysia. Main contents of red gypsum were ...
    • Environmental friendly mineral block 

      Siti Nurfadilah, Arshad (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010-04)
      Mineral block are common supplement food sources of ruminants animals that usually use by farmer. It can be found either in the wild or through solidification process. The aim of this study is to enhance utilization of ...
    • Health effect of sugarcane farm burning on resident of Wang Ulu, Kangar, Perlis 

      Syakirah, Abdul Razak (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010-04)
      The first thought that comes to mind concerning air pollution is related to urban centers where automotive exhausts and the industrial chimneys are the most important sources of atmospheric pollutants. However, in Perlis, ...
    • A study of water quality for Sungai Perlis during high tide and low tide 

      Nur Shahidah, Mohd Nasir (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010-04)
      Sungai Perlis is the main river in Perlis with length is approximately 9.55 km from Kangar city to Kuala Perlis before discharged to the sea. The size of the Sungai Perlis basin is approximately 310 km2. The objectives ...
    • Acclimatization and performance study of palm oil mill effluent (POME) in closed anaerobic reactor 

      Lim, Kok Keat (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010-04)
      Anaerobic reactor system is particularly effective to reduce pollutant of the high strength wastewater and produces the biogas. POME wastewater considered as polluting contaminants due to its high organic load was treated ...
    • A study on solid waste Management at Kg. Jelempok, Arau 

      Shazryenna, Dalang (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010-04)
      Solid waste management has six main functional elements. There are Waste Generation, Storage, Collection, Transportation, Recycle and Process and Disposal. Problem can occur in any stage of the management. In Malaysia, ...
    • Production of activated carbon using Musa Acuminata 

      Nurhusna, Fuad (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010-04)
      The sorption of acid orange 7 dyes from aqueous solution by banana stalk, an abundant agricultural waste in Malaysia was studied in a batch system with respect to contact time and activated carbon dosage. Sorption isotherm ...
    • ZnO-mediated solar photocatalytic degradation of azo dye 

      Siti Zharifah, Roba’ai (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010-04)
      Wastewaters generated from the textile industry contain large amounts of azo dyes which, owning to their non-biodegradability, toxicity and potential carcinogenic nature, constitute a major threat to the surrounding ...
    • Study on application of horizontal and vertical sub surface flow constructed wetland for landfill leachate treatment 

      Mohd Abd Hafiz, Zakaria (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010-04)
      Leachate is one of the major problems in landfill since it contained high levels of organic and inorganic matters. As it was highly contaminated, leachate could not be discharged directly into the surface water bodies. ...
    • Phytoremediation of azo dye acid orange 7 with mycrophyte Typha Latifolia sp. using up- flow constructed wetland 

      Nur Hafizah, Samad (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010-04)
      Combination of aerobic and anaerobic processes in constructed wetlands can enhance the treatment performance in textile wastewater. This study assessed the treatment of azo dye Acid Orange 7 (AO7) and nutrients using ...
    • Characteristic of light weight aggregate (Palm oil clinker) 

      Norazrin, Ramli (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010-04)
      Lightweight aggregate (LWA) is a lightweight inert material, such as foamed slag, vermiculite, clinker, and perlite. The palm oil clinker (POC) is one of the agricultural waste, produced in abundance has the potential to ...