Browsing School of Microelectronic Engineering (FYP) by Subject "Amplifiers"

Now showing items 1-6 of 6

    • Analysis the role of supply voltage and load capacitor in small-signal MOSFET amplifiers 

      Mohd Iskandar Jalaludin (Universiti Malaysia PerlisSchool of Microelectronic Engineering, 2008-03)
      The main objective of this project is to investigate the role of supply voltage and load capacitance in the performance of small-signal MOS amplifier with the PSpice simulation for the Common Source, Common Gate and Common ...

    • CMOS Two Stage OP-AMP analysis and design 

      Ahmed Syafiq, Ab Kadir (Universiti Malaysia PerlisSchool of Microelectronic Engineering, 2008-03)
      The design and analysis CMOS of Two Stage Operational Amplifier that presented has constructed with two basic amplifier which is diffential amplifier and single stage amplifier. The design need to achieve the value that ...

    • Design a Wideband Low-Noise Amplifier for Wireless Communication using 0.35-µm CMOS Technology 

      Mohd Hafiz Abu (Universiti Malaysia PerlisSchool of Microelectronic Engineering, 2007-03)
      Low Noise Amplifier (LNA) is one of the receiver front end component. Place near antenna, this part used to minimize the noise figure of the amplifier while providing enough gain with sufficient linearity to overcome the ...

    • Design and analysis CMOS Cascode amplifier 

      Che Mohd Amirul Azam Che Mohd Ghani (Universiti Malaysia PerlisSchool of Microelectronic Engineering, 2008-03)
      The design of CMOS cascode amplier is presented which it will constructed with the circuit of current mirror and two transistor are placed in cascode topology. The design need to achieve the value that will meet the ...

    • Design and Simulation of CMOS Operational Amplifier using Mentor Graphics Tool 

      Jegatheesan Sri Ramalu (Universiti Malaysia PerlisSchool of Microelectronic Engineering, 2007-04)
      Today’s atmosphere and demands continue to drive operating voltages down, especially for widely used components such as the Operational Amplifier. Some of the motivations driving the market are integration, battery operated ...

    • Stable 2 Stage CMOS Amplifier 

      Ahmad Zainoldiar, Khalidi (Universiti Malaysia PerlisSchool of Microelectronic Engineering, 2007-04)
      In the last few years there has been an effort to integrate electrochemical instrumentation. A critical component of such a system is an amplifier. These projects design a “Stable Two stage CMOS amplifier”. This is achieved ...